5pce TCT Hollowing Set
1 x $300.00 = $300.005/8 Drive Dog #2 Morse Taper
1 x $36.36 = $36.36NI-Chrome Wire
1 x $13.64 = $13.64DMT Diamond Hone Coarse
1 x $18.18 = $18.18Tool Rest 230mm with 30mm Post
1 x $59.09 = $59.09Rapid Cure 250ml
1 x $49.09 = $49.09DMT Diamond Hone Extra Fine
1 x $18.18 = $18.18Henry Taylor Elf Bud Cutter
1 x $18.18 = $18.18Tool Rest 230mm with 1 inch Post
1 x $50.00 = $50.00230mm Velcro Sanding Disc 80 grit
1 x $7.27 = $7.27NCF Quick Accelerator
1 x $43.64 = $43.641710 x 1/4 x 4 TPI
1 x $27.27 = $27.27100mm Chuck Insert 18 x 2.5
1 x $40.91 = $40.9110mm Brad Point Drill
1 x $9.09 = $9.0912 inch Thicknesser Drive Belt
1 x $34.55 = $34.55QWS WL1624VF Variable Speed Woodlathe
1 x $2,544.55 = $2,544.555pce Mortise Chisel Set
1 x $90.00 = $90.00- $3,696.00
- Shopping cart Checkout
- Catalog
Categories
8 inch Slow Bench Grinder
This solidly made 200mm Trade rated grinder is fitted with a 60g grey and a 120g white aluminium oxide wheel, both 32mm wide and well suited to the edge tool grinding needs of the woodworker or turner. The speed is reduced to 1,425rpm thus reducing the peripheral speed and the potential to overheat the tool. The base is 200 x 320mm and has four fixing points. The 900W induction motor runs exceptionally smoothly and provides adequate power for all types of grinding. The guards are very solid andhave 40mm diameter outlets at the rear for connection to an extraction system. The tool rests and eye shields are robustly made, the eye shields being fully adjustable to any position. Finally, to finish off a good job the grinder is fitted with an LED work lightand no-volt-release switch. Please note, SIT Wire Brushes not compatible with this grinder.