MC1218 Drive Belt
1 x $34.55 = $34.55MC900/1100 Drive Belt
1 x $22.73 = $22.73Robert Sorby Hollowing Tool RS230KT
1 x $156.36 = $156.36Hisimen 10 inch Bandsaw
1 x $453.64 = $453.64Rifle Pen Clip Chrome PK of 5
1 x $12.73 = $12.73Woodies Gear Dust Coat
1 x $52.73 = $52.7325 metre Drum Sander Rolls 100 Grit
1 x $86.36 = $86.36Drum Sander Wrap 100 Grit
1 x $16.36 = $16.3625 metre Drum Sander Rolls 60 Grit
1 x $86.36 = $86.36RZ Filter F1 Medium
1 x $27.27 = $27.27Safety Specs
1 x $4.55 = $4.5514 LED Magnifying Lamp
1 x $71.82 = $71.82NVR Type (No Volt Release) switch
1 x $34.55 = $34.551632 Conveyor Rubber Belt (Platen)
1 x $127.27 = $127.27MC900/100 Reeves Pulleys
1 x $100.00 = $100.00MC1018 Drive Belt
1 x $34.55 = $34.55PowerCap IP Face Seal
1 x $23.64 = $23.64Robert Sorby Turnmaster
1 x $208.18 = $208.18JSP IP Active Powercap Respirator
1 x $863.64 = $863.6425 metre Drum Sander Rolls 180 Grit
1 x $86.36 = $86.3625 metre Drum Sander Rolls 120 Grit
1 x $86.36 = $86.36Tip 14M - Medium Knife
1 x $8.18 = $8.18TH16L Large 45 Degree Shader - Heavy Duty Tip Only.
1 x $8.18 = $8.18TH6LC Large Chisel Shader - Heavy Duty Tip Only
1 x $8.18 = $8.18TH16S Small 45 Degree Shader - Heavy Duty Tip Only.
1 x $8.18 = $8.18Ironcore
1 x $245.45 = $245.45SET3-T98 3 pce Bead Makers Set Tips Only
1 x $30.00 = $30.00Tip 7M - Medium Round Skew
1 x $8.18 = $8.18- $3,197.00
- Shopping cart Checkout
Axminster Live Centre with Chip Ejection #2MT
An excellent improvement to our standard hollow live centre, this Evolution Series centre features three chip ejection ports so that during use the bit doesn't have to be completely withdrawn from the tailstock. With short and long removable points, twin ball bearings and an 8mm(5/16") diameter through hole, this centre is an invaluable aid when long hole boring. The short point protrudes a mere 3mm beyond the ring and allows an accurate impression of the ring to be made on the end of the timber. Having made the impression, the point can be removed from the centre and the work relocated on the ring impression, allowing an accurate hole to be bored. When boring right through, the timber is drilled from one end then reversed, a counterbore drive is used to hold the timber in the headstock and the boring process repeated from the tailstock end. Fitting the long point gives good access for all sorts of miniature work, including light pulls and lace bobbins. A truly multi-functional accessory, worthy of a place in any turner's tool kit.